Week 10: Completing the hardware design

Title: Completing the hardware design

Objective: 


 To complete the hardware design of the project.
To attach all the hardware components in a box casing.



Progress: 






Conclusion:

                    As the conclusion, by the end of this week, I finally manage to design a prototype.

Comments

Post a Comment

Popular posts from this blog

week 12: Testing and Troubleshooting

Image
Title:  Testing and Troubleshooting Objective:  To test the functionality of my project Progress:                 Last week I tested the function of the Blynk application and the result as desired.  for this week, I need to test the functionality of my project installed in the prototype as shown in the figure below. The prototype of project There are no presences of gas leakage so that the display show “Gas normal” and the exhaust fan is in a turn off situation means the sensor did not receive any signal.  when the gas detected by the sensor. The MQ6 sensor sends data to Arduino and gives the high output to activate the exhaust fans, buzzer and display the “Gas alert” in the LCD display .  Conclusion:                     As the conclusion, by the end of this week, I finally manage to test the prototype and get the result as desire...
Read more

Week 14: Final Year Project Presentation Day

Image
Title: Final Year Project Presentation Day Objective:  To present the poster and demonstrate the final year project.      Method: Present the poster and slide to the assessor, demonstrate the hardware project, answer questions and being evaluated by the assessor. Progress:  The Final Year Presentation  (FYP 2) took place in the Dewan Gemilang, Unikl British Malaysian Institute (BMI) on 2 May 2018. The presentation started at 8:30 in the morning. I was assigned to two assessors from the FYP committee who are lecturers from the Electrical Section.  Conclusion: Everything went well for the presentation. After the presentation is time to prepare the report
Read more

Week 16: Plagiarism check for the report

Image
Title: Plagiarism check for the report Activity:  Do correction if greater than 20% ObjeCtive: to finish the report and follow the format Content: The report has been check by Turnitin software Result and analysis:  The result from Turnitin software. Conclusion   :      By the end of this week, I finished to complete my plagiarism and printed out the result. 
Read more